P0800
Transfer Case Control System (MIL Request)
P0800 works like P0700 for the transmission: the transfer case control module has detected a fault of its own that it rates as emissions-relevant and asks the engine control module to turn on the MIL. The engine module only stores P0800; the actual fault – often C, U or manufacturer codes – sits in the transfer case module and needs a scan tool that addresses it. CARB requires monitoring of an electronic transfer case only where it feeds other diagnostics, for example the 4WD-low signal that GM uses as an enable condition; this is why most transfer case modules never request the MIL and P0800 hardly appears in manufacturer documents. A GM bulletin for 2020–23 trucks with 'Service 4WD' and the MIL points to wiring and terminal contact at the transfer case.
Possible causes
- Fault in the transfer case system stored in its module (shift motor, sensor, clutch) high
- Wiring or connector at the transfer case (terminal tension, corrosion) medium
- Transfer case module software medium
- Transfer case module faulty low
Symptoms
- Check engine lamp on
- 'Service 4WD' or similar warning
- All-wheel drive or low range cannot be selected
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P0800
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.