P07F3
Transmission Range Control Module Communication Circuit Low
The transmission range control module is the separate shift-by-wire control unit that reads the selector and drives the range actuator. P07F3 is the electrical low check of its communication line: the line is shorted to ground and stays at a low level. No manufacturer document available to us uses it; the code fits a dedicated signal or redundancy line between selector, range control module and transmission or engine module rather than a CAN bus. GM handles a bus short under its own U2409 (bus off for 1 s, two trips). The module may block range changes or select neutral.
Possible causes
- Communication wire shorted to ground medium
- Module output stage faulty low
- Moisture or corrosion in the connector low
Symptoms
- Shift warning
- Possible shift lock or neutral (depends on manufacturer)
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P07F3
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.