P07EA
Transmission Range Control A Circuit Low
Despite its name, 'Transmission Range Control A' is not the range actuator motor – that has its own codes, P272A and P272B – but the sensor circuits of an electric shift-by-wire selector. The only documented user is Mitsubishi's 2022 service manual for a CVT with electric shift (very likely the 2022–23 Outlander): the lever carries eight position sensors whose on/off pattern encodes R, N, home, D and M. P07EA is the electrical low check: one sensor reads below 0.6 V for 2.4 s – a signal wire shorted to ground or a missing sensor supply. Mitsubishi defines no fail-safe reaction. If all bits drop out at once, P07EF follows and the transmission goes to neutral.
Possible causes
- Selector sensor wire shorted to ground (chafed harness, connector) high
- Sensor supply in the selector open medium
- Selector or module faulty medium
Symptoms
- Electric shift or check engine warning
- Usually no noticeable restriction
- Further sensor faults lead to P07EC/P07ED
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P07EA
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.