OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P07E5

Unable to Engage Drive

With shift-by-wire or park-by-wire, P, R, N and D are requested electrically (buttons, rotary selector, automatic park on shutdown) and an actuator moves the selector shaft or the park pawl; the module compares the requested with the range actually reached. P07E5 means drive is requested but not reached in time. Only GM documents it: its electronic range selector (LaCrosse, XT5, XT4, 2025 Equinox and Terrain) allows 10 s in most tables, 3 s in the 2018 Diesel table and 2000 ms in the selector module, type B with the MIL after two trips. A 2018 bulletin blames a misaligned range control module coupling, its 2019 revision adds ratio codes; on the 2025 Equinox and Terrain it can appear after an over-the-air update and clears after a ten-minute rest. The car does not move forward or falls back to neutral.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number7 / E5

Possible causes

  • Range control actuator misaligned or faulty high
  • Software or after-effect of an over-the-air update medium
  • Range sensor signal wrong medium
  • Forward clutch or line pressure missing low

Symptoms

  • No drive in D
  • 'Service Transmission' message, MIL
  • Range falls back to N or P

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P07E5

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication