OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P07E1

Incorrect Shift from Gear 6

The series 'Incorrect Shift from Gear N' (P07DC–P07E3 for gears 1–8, P07FA and P07FD for 9 and 10) covers a shift that leaves the starting gear but lands in a gear other than the commanded target – a skipped or overshot gear. A module can see this after the shift because the measured ratio matches the wrong gear. No manufacturer document available to us uses the series: Ford assigns such patterns to the shift solenoid that caused them (P0751 ff), newer GM automatics report clutch pressure valve codes. P07E1 starts from gear 6. It differs from P0729 (wrong ratio while in gear 6, a slipping clutch), P073B (gear 6 cannot be left) and P0780 (the shift itself takes too long or flares). Detection, MIL and trip count therefore follow only by analogy from CARB's functional check and Ford's ratio and shift completion checks.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number7 / E1

Possible causes

  • Shift or pressure control valve sticking in the valve body high
  • Clutch or brake pack worn or leaking medium
  • Fluid low or contaminated medium
  • Wrong adaptives or software medium
  • Turbine or output speed signal wrong low

Symptoms

  • Wrong or skipped gear when shifting out of gear 6
  • Harsh shift or engine speed jump
  • Transmission warning, possibly limp mode in a fixed gear

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P07E1

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication