Powertrain
generic / SAE
P07D2
Transmission Mode Switch E Circuit Low
Mode switch E input reads stuck low. Wiring faults of this kind typically come from chafing, water ingress at connector seals, or pin push-back — a wiggle test on the harness while the code is active often confirms the location.
SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number7 / D2
Possible causes
- Switch wire shorted to ground high
- Connector pins corroded - high contact resistance low
- Harness chafing through insulation low
Symptoms
- Check engine or transmission warning light on
- Harsh, delayed, or missing shifts
- Possible limp mode (locked in one gear)
- Slipping or shuddering during gear changes
Inspection / repair
- Difficulty: medium
- DIY: possible
Pro mode: costs, time and components
Free with the newsletter by Fabian Brose: enter your name and email, confirm by mail – Pro mode is then unlocked on this device for 30 days. The newsletter arrives about every two weeks, unsubscribe at any time. Already subscribed? One click is enough – you will be recognised.
Unlock Pro mode for freeSources
References
sae:J2012