OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P07C7

Intermediate Shaft Speed Sensor B Circuit Low

These low/high codes are a purely electrical check of the sensor's signal voltage at the module and run even with the vehicle at rest – unlike the circuit, range, no-signal and intermittent codes, which evaluate speed while driving. Low means a short to ground, high a short to supply or, depending on the circuit, an open. Intermediate shaft sensor B is a further sensor on a countershaft or planetary element. No manufacturer document available to us uses this code; GM reports further 10-speed intermediate sensors under its own codes. The expected logic follows the other sensors (below about 0.25 V); the speed-based codes for sensor B are P2745–P2748.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number7 / C7

Possible causes

  • Signal or supply wire shorted to ground (chafing at the case) high
  • Sensor shorted internally medium
  • Oil or moisture in the connector medium
  • Module input faulty low

Symptoms

  • Check engine light (GM after one trip)
  • Limp mode, harsh shifts, no converter lock-up
  • Adaption frozen

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P07C7

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication