P07C3
Input/Turbine Shaft Speed Sensor C Circuit Low
These low/high codes are a purely electrical check of the sensor's signal voltage at the module and run even with the vehicle at rest – unlike the circuit, range, no-signal and intermittent codes, which evaluate speed while driving. Low means a short to ground, high a short to supply or, depending on the circuit, an open. No manufacturer document available to us uses this code, and no production transmission with a third input speed sensor was found. The expected logic follows GM's sensor A check (below 0.25 V); the remaining codes for sensor C are P07F1 ff.
Possible causes
- Signal or supply wire shorted to ground (chafing at the case) high
- Sensor shorted internally medium
- Oil or moisture in the connector medium
- Module input faulty low
Symptoms
- Check engine light (GM after one trip)
- Limp mode, harsh shifts, no converter lock-up
- Adaption frozen
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P07C3
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.