P07C0
Input/Turbine Shaft Speed Sensor A Circuit High
These low/high codes are a purely electrical check of the sensor's signal voltage at the module and run even with the vehicle at rest – unlike the circuit, range, no-signal and intermittent codes, which evaluate speed while driving. Low means a short to ground, high a short to supply or, depending on the circuit, an open. GM's transmission modules from 2019 (9-speed, 10-speed) flag below 0.25 V or above 4.75 V – a short of under 0.5 Ω – for more than 0.05 s with the system above 10 V for 5 s, after one trip. P07C0 is the high side: a short of the input sensor signal to supply. GM's 2019 nine-speed bulletin lists it together with P07BF and P0717 and traces it to an open inside the sensor.
Possible causes
- Signal wire shorted to supply high
- Open circuit or broken wire inside the sensor medium
- Corroded connector medium
- Module input faulty low
Symptoms
- Check engine light (GM after one trip)
- Limp mode, harsh shifts, no converter lock-up
- Adaption frozen
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P07C0
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.