P07B7
Transmission Park Position Sensor/Switch A Circuit Intermittent/Erratic
With electronic gear selection the park position sensor/switch reports the park request or position. On GM's shift-by-wire selectors (2017 LaCrosse, XT4/XT5, Bolt EV, later SUVs and pickups) it is the P button, read by two redundant analog sensors A and B with separate 'released' and 'pressed' voltage zones. P07B7 means sensor A's signal jumps or drops out intermittently. No manufacturer document available to us uses this code; GM covers intermittent P button problems as zone or correlation faults (P07B5, P07BE); its bulletins note that off-centre pressing or a hand resting on the button can be enough. A loose contact is the likely cause.
Possible causes
- Loose contact in the selector connector or harness high
- Sensor with intermittent fault medium
- Off-centre pressing or a hand resting on the button low
Symptoms
- Check engine light, 'service transmission' or 'unable to shift' message
- Park cannot be selected by button, or the car will not shift out of P
- P button illumination off
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P07B7
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.