P07B2
Transmission Park Position Sensor/Switch A Circuit/Open
With electronic gear selection the park position sensor/switch reports the park request or position. On GM's shift-by-wire selectors (2017 LaCrosse, XT4/XT5, Bolt EV, later SUVs and pickups) it is the P button, read by two redundant analog sensors A and B with separate 'released' and 'pressed' voltage zones. P07B2 means the circuit of sensor A is open: the module sees a missing or undefined signal. No manufacturer document available to us uses this code; GM covers an open analog circuit under its low and high codes (P07B3/P07B4), which CARB allows when an open cannot be told apart from an out-of-range value. Park may then not be selectable by button.
Possible causes
- Wire or connector to the selector open high
- Connector not latched medium
- Sensor faulty medium
Symptoms
- Check engine light, 'service transmission' or 'unable to shift' message
- Park cannot be selected by button, or the car will not shift out of P
- P button illumination off
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P07B2
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.