P0794
Intermediate Shaft Speed Sensor A Circuit Intermittent
The intermediate shaft speed sensor measures a shaft between input and output – a countershaft on Toyota's U760 six-speed, the intermediate shaft behind the overdrive set on Ford's 5R110W. Together with turbine and output speed it lets the module check each gear stage and control clutch slip. P0794 means the intermediate shaft signal drops out or jumps briefly – not long enough for P0793 – typically a loose contact or a wire breaking under movement. No manufacturer document available to us uses this code; the expected logic counts unrealistic jumps like Ford's P0718 for the turbine sensor (200 spikes within 1.5 s each). Occasional harsh shifts follow, and limp mode after several events.
Possible causes
- Loose contact at the connector or broken wire high
- Sensor thermally unstable medium
- Interference (ground, shielding) low
Symptoms
- Occasional transmission warning
- Harsh shift now and then
- Limp mode, gone after restart
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P0794
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.