OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0791

Intermediate Shaft Speed Sensor A Circuit

The intermediate shaft speed sensor measures a shaft between input and output – a countershaft on Toyota's U760 six-speed, the intermediate shaft behind the overdrive set on Ford's 5R110W. Together with turbine and output speed it lets the module check each gear stage and control clutch slip. Ford uses P0791 as its only intermediate shaft code, for 'no or too little signal': while the vehicle drives under power (turbine at least 1500 rpm, output at least 650 rpm or 15 mph), the sensor reports below 250 rpm for 5 s – in the 2012 and 2020–23 summaries, with MIL. A Toyota bulletin for the U760 (Highlander, Venza, Camry 2009–10) replaces the countershaft sensor for P0791/P0793. GM's 10-speed has two such sensors but uses its own codes. Limp mode and harsh shifts follow.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number7 / 91

Possible causes

  • Intermediate shaft speed sensor faulty high
  • Connector or wire at the transmission (oil, corrosion, chafing) medium
  • Reluctor wheel damaged or debris on the sensor medium
  • Control module low

Symptoms

  • Check engine light
  • Limp mode or fixed gear
  • Harsh or delayed shifts
  • Follow-up pressure control codes (Toyota)

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P0791

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication