OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P077D

Output Shaft Speed Sensor Circuit High

GM's transmission modules from 2019 to 2025 (9- and 10-speeds) also read the active output speed sensor's line voltage as an analog value. P077D is the mirror of P077C: the voltage is above 4.75 V – a short to the module supply of under about 0.5 Ω – for more than 0.05 s, after one trip. GM then blocks the no-signal and ratio checks; a GM hybrid also blocks its idle diagnosis. Without usable output speed the transmission enters limp mode, and speedometer or cruise control may fail.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number7 / 7D

Possible causes

  • Signal wire shorted to sensor supply or battery voltage high
  • Sensor faulty internally medium
  • Ground fault at the sensor, corroded connector medium
  • Module input low

Symptoms

  • Check engine light at once (GM)
  • Limp mode
  • Speedometer or cruise control failed
  • Shift problems

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P077D

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication