OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0760

Shift Solenoid C

A shift solenoid is an electrically switched valve in the valve body. Manufacturers use these codes differently: Ford reports an open circuit with the base code and shorts separately, and the letter is not tied to a valve number (Saab's Aisin 9-5: C = valve S4, D = valve S5). P0760 is the general code for solenoid C and, at Ford, means an open circuit: the smart driver feedback disagrees with the command for 0.5–5 s, continuously; shorts to ground and power are P0979/P0980. On Ford's 6R80, 6F35/6F55 and 6R140, solenoid C is the proportional valve of the CB26 brake for second and sixth gear. If the solenoid supply is switched off, Ford transmissions keep park, reverse, neutral and fifth gear with maximum pressure.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number7 / 60

Possible causes

  • Open or corroded wire, connector or internal harness high
  • Solenoid coil open or shorted medium
  • Solenoid supply (high-side switch) missing low
  • Module driver faulty low

Symptoms

  • Check engine or transmission warning lamp
  • Limp mode in a fixed gear (Ford: fifth with maximum pressure)
  • Second and sixth gear missing (Ford CB26)

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P0760

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication