P0749
Pressure Control Solenoid A Intermittent
Pressure control solenoid A sets line or clutch pressure by current; most are 'normally high', so with no current – as in limp mode – maximum pressure applies. 'A' is usually the line pressure valve, on GM clutch-to-clutch transmissions (6T, 8L, 9T) the pressure valve of clutch 1. Ford does not use P0745–P0749 but P0960–P0963. P0749 is an intermittent fault in the circuit of this valve. No manufacturer document available to us uses it; Mitsubishi defines the sister code for valve B (P0779) as circuit open or shorted to positive for 1 s. Brief current or voltage dropouts make the module switch the valve off – maximum pressure – and retest it, so harsh shifts or limp mode appear at times and vanish after a restart.
Possible causes
- Loose contact or corrosion at the transmission connector high
- Chafed harness (intermittent short) medium
- Valve with temperature-dependent winding fault medium
- Voltage dips or poor ground low
Symptoms
- Harsh shifts at times
- Occasional limp mode, normal again after restart
- Warning lamp (sometimes only stored)
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P0749
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.