OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0748

Pressure Control Solenoid A Electrical

Pressure control solenoid A sets line or clutch pressure by current; most are 'normally high', so with no current – as in limp mode – maximum pressure applies. 'A' is usually the line pressure valve, on GM clutch-to-clutch transmissions (6T, 8L, 9T) the pressure valve of clutch 1. Ford does not use P0745–P0749 but P0960–P0963. P0748 is the electrical code of this valve, checked by current, duty cycle or terminal voltage: Subaru after 0.14 s with MIL after two trips and limp mode in third, Allison against an 8 Ω current model after 125 ms, GM's diesel 4L80-E for a duty cycle outside 0.5–95 % for 2 s without MIL. The valve is switched off – maximum pressure, harsh shifts, frozen adaption, often a fixed gear (Saab AF40: second and reverse) and reduced torque. Saab's 2010 9-5 uses P0748 for a current deviation instead.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number7 / 48

Possible causes

  • Harness or transmission connector (corrosion, oil, chafing) high
  • Pressure control solenoid faulty (resistance out of spec) high
  • Internal harness, electronic module or mechatronic unit medium
  • System voltage too low low
  • Transmission module driver low

Symptoms

  • Harsh shifts or engagement (maximum pressure)
  • Limp mode in a fixed gear
  • Transmission warning or check engine light
  • Reduced engine power (torque limit)

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P0748

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication