OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0747

Pressure Control Solenoid A Stuck On

Pressure control solenoid A sets line or clutch pressure by current; most are 'normally high', so with no current – as in limp mode – maximum pressure applies. 'A' is usually the line pressure valve, on GM clutch-to-clutch transmissions (6T, 8L, 9T) the pressure valve of clutch 1. Ford does not use P0745–P0749 but P0960–P0963. P0747 means the valve is electrically fine but pressure stays applied. On GM's clutch-to-clutch units the off-going clutch 1 does not release – slip stays below 50 rpm (9-speed, 0.8 s on loaded downshifts), and Allison flags 25 rpm or less for 0.3–1 s, both after one trip. On line pressure valves it means permanently high pressure. Harsh, abrupt shifts, a tied-up transmission and a default gear follow. GM noted false settings on 2017 8-speeds: clear and retest first.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number7 / 47

Possible causes

  • Pressure or clutch valve or spool sticking (dirt, debris) high
  • Valve body worn medium
  • Software or false setting medium
  • Wrong or contaminated fluid medium
  • Clutch plates stuck or burnt low

Symptoms

  • Harsh, abrupt shifts
  • Transmission ties up, engine speed drops on shifts
  • Limp mode or default gear
  • Check engine light

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P0747

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication