OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0745

Pressure Control Solenoid A

Pressure control solenoid A sets line or clutch pressure by current; most are 'normally high', so with no current – as in limp mode – maximum pressure applies. 'A' is usually the line pressure valve, on GM clutch-to-clutch transmissions (6T, 8L, 9T) the pressure valve of clutch 1. Ford does not use P0745–P0749 but P0960–P0963. P0745 is the general code for this valve; the sub-codes P0746–P0749 follow. It is documented on Mitsubishi CVTs as a current plausibility check: at most 400 mA while 750 mA or more is commanded for 5 s, or 1.34 A or more for 1 s. A failure usually leaves the valve unpowered, so pressure goes to maximum: harsh shifts and, depending on the transmission, limp mode in a fixed gear.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number7 / 45

Possible causes

  • Pressure control solenoid (coil) faulty high
  • Transmission harness or connector high
  • Contaminated fluid, valve sluggish medium
  • Transmission module low

Symptoms

  • Harsh shifts or engagement (maximum pressure)
  • Limp mode in a fixed gear
  • Transmission warning or check engine light

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P0745

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication