OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0743

Torque Converter Clutch Circuit Electrical

The torque converter clutch (lock-up) connects pump and turbine mechanically; a solenoid – on/off, pulse-width modulated or proportional – moves a control valve in the valve body. Slip is engine speed minus turbine speed. Manufacturers do not use P0740–P0744 uniformly: Ford uses P0740 for open, P0742 for short to ground and P0744 for short to power, and reports stuck on as P2758. P0743 is the collective electrical code for the converter clutch solenoid circuit – open, short to ground or to positive – detected by terminal voltage, driver feedback or current. Subaru flags it after 0.14 s and lights the MIL after two trips, Saab's 9-3 of 2003 above 1356 mA for 500 ms, Allison after 1.5 s; older Ford transmissions also use it. The clutch is switched off; Saab's Aisin boxes go into limp mode, Subaru does not.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number7 / 43

Possible causes

  • Transmission harness or pass-through connector (corrosion, chafing, oil in connector) high
  • Solenoid coil open or shorted high
  • Internal harness or mechatronic unit medium
  • Driver stage in the transmission or engine module low

Symptoms

  • Check engine light or transmission warning
  • No lock-up: engine speed about 100–300 rpm higher when cruising
  • Limp mode on some makes (Saab/Aisin)

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P0743

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication