OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0740

Torque Converter Clutch Circuit/Open

The torque converter clutch (lock-up) connects pump and turbine mechanically; a solenoid – on/off, pulse-width modulated or proportional – moves a control valve in the valve body. Slip is engine speed minus turbine speed. Manufacturers do not use P0740–P0744 uniformly: Ford uses P0740 for open, P0742 for short to ground and P0744 for short to power, and reports stuck on as P2758. P0740 concerns the control circuit of the converter clutch solenoid. Ford flags an open circuit when the driver feedback line disagrees with the command for 0.5–5 s, with MIL; a 2006 GM table checks 0/12 V with more than 43 of 50 failed counts after two trips – newer GM units use P2761/P2763/P2764. FCA's Ram 6.7 reads P0740 as converter slip out of range and moved it to two trips by software in 2013. The clutch is then switched off: higher engine speed when cruising, more fuel, hotter fluid.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number7 / 40

Possible causes

  • Open or corroded harness or transmission pass-through connector high
  • Converter clutch solenoid coil open medium
  • Internal transmission harness or mechatronic unit medium
  • Driver stage in the module faulty low
  • FCA: actual converter slip (clutch wear, fluid) or software low

Symptoms

  • Check engine light or transmission warning
  • No lock-up: engine speed about 100–300 rpm higher when cruising
  • Higher fuel consumption, hotter transmission fluid

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P0740

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication