OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P073D

Unable to Engage Neutral

P073D means neutral is commanded but not reached or not held. GM uses it on vehicles with electronic gear selection (shift-by-wire, e.g. Cadillac XT4): the selector or engine module compares commanded and actual range from the range sensor and flags it after 1.8–2 s in the selector module or 10 s in the engine module, after two trips. For Ford's 6F35 the supplier Sonnax describes a mechanical cause: a forward or direct clutch dragging in neutral, visible as turbine speed staying only 200–400 rpm below engine speed. The car may creep in N; range changes may be locked. The opposite, stuck in neutral, is P072A.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number7 / 3D

Possible causes

  • Ford 6F35: forward or direct clutch dragging (balance piston, plates, seal) high
  • Shift-by-wire: range actuator or park module, range sensor or its calibration medium
  • Valve body (manual valve, missing check ball, sticking solenoid) medium
  • CAN communication or control module low

Symptoms

  • Vehicle creeps in N or engine is loaded when shifting to N
  • N selection not accepted, warning message
  • Harsh engagement N to D/R (6F35)
  • Check engine light after two trips (GM)

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P073D

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication