P0738
TCM Engine Speed Output Circuit Low
Some transmission modules pass an engine speed signal on to other devices such as a tachometer over a wire of their own. CARB requires output circuits to be checked. No manufacturer document available to us uses P0737–P0739 – engine speed is shared over CAN today; the description follows CARB and the engine module's own speed output (P0654), which sends, for example, two pulses per revolution. P0738 means this output is too low, typically shorted to ground, so it can no longer switch high. The opposite is P0739, the general fault P0737. A tachometer or dependent display then reads zero or jumps, while driving is usually unaffected.
Possible causes
- Output wire shorted to ground high
- Receiver shorted internally medium
- Connector corroded medium
- Driver stage in the transmission module faulty low
Symptoms
- Tachometer at zero or jumping
- Warning lamp depending on manufacturer
- Usually no effect on driving
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P0738
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.