P0737
TCM Engine Speed Output Circuit
Some transmission modules pass an engine speed signal on to other devices such as a tachometer over a wire of their own. CARB requires output circuits to be checked. No manufacturer document available to us uses P0737–P0739 – engine speed is shared over CAN today; the description follows CARB and the engine module's own speed output (P0654), which sends, for example, two pulses per revolution. P0737 is the general circuit fault of this output; low and high are P0738/P0739. Not to be confused with the engine speed input at the transmission module (P0725 ff). A tachometer or dependent display then reads wrong or nothing, while driving is usually unaffected.
Possible causes
- Wire to the receiver open or shorted high
- Receiver (e.g. instrument cluster) shorted internally medium
- Connector corroded medium
- Driver stage in the transmission module faulty low
Symptoms
- Tachometer or dependent display not working or wrong
- Warning lamp depending on manufacturer
- Usually no effect on driving
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P0737
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.