OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0732

Gear 2 Incorrect Ratio

The transmission module divides input (turbine) speed by output speed and compares the result with the ratio of the commanded gear; a deviation means slip – a clutch or brake not holding, too little pressure – or a wrong gear. Thresholds: Ford more than 30 rpm off for 1.8 s three times (diesel 2023: over 20 % for 12 s), GM's 2006 tables and the Allison 1000 converter slip of 200–230 rpm for 2.25 s after one trip, Saab's Aisin boxes over 20 % twelve times without MIL. P0732 concerns second gear. In the Aisin limp mode, with all solenoids unpowered, second gear is the one left – so slip there also affects limp-home driving. Ford stores it only if the fault fits no particular solenoid. On GM manual transmissions it checks the gear position sensor instead.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number7 / 32

Possible causes

  • Fluid level too low or fluid worn or contaminated high
  • Clutch or brake for second gear worn (linings, piston seal) high
  • Sticking shift or pressure valve, leaking valve body gasket, blocked passages medium
  • GM manual transmissions only: gear position sensor faulty or not learned medium

Symptoms

  • Slipping or flare in second gear, engine speed higher than expected
  • Harsh or delayed shifts
  • Limp mode (Aisin: second gear and reverse only), transmission warning
  • Check engine light depending on manufacturer

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P0732

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication