P0730
Incorrect Gear Ratio
P0730 reports a wrong transmission ratio without assigning it to a gear. Two uses are documented. Older Aisin-type automatics (a 2006 GM table, Saab's 9-5 of 2002) set it when fourth or fifth gear shows the ratio of third – a shift solenoid (Saab: S3) is not switching; GM lights the MIL at once, Saab enters limp mode. GM's continuously variable transmissions of 2023 and 2025 use it when the pulleys do not reach the commanded variator ratio – the belt or chain slips or clamping pressure is too low – after one trip. Ford and newer GM step automatics use gear-specific or clutch valve codes instead. Check fluid level and condition first.
Possible causes
- Fluid level or quality (CVT fluid or ATF) high
- Shift solenoid or pressure control valve sticking or faulty high
- Clutch or brake wear, or worn variator belt, chain or pulleys medium
- Faulty speed sensor signal low
Symptoms
- Slipping, engine speed rises without drive
- Wrong gear or missing upper gears, limp mode
- Check engine light (GM) or transmission warning
- CVT: judder, weak acceleration
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P0730
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.