P0727
Engine Speed Input Circuit No Signal
The transmission module needs engine speed for converter slip, shift quality and to check the turbine speed. Today it almost always arrives over CAN from the engine module with a validity flag; only GM's 2007 Allison 1000 tables show a separate engine speed sensor read by the transmission module. P0727 means the engine speed signal is missing although the transmission is turning. The Allison 1000 flags under 61 rpm for 4 s with turbine speed of 400 rpm or more, after two trips; Saab's 9-3 of 2000 input speed above 2000 rpm for more than 5 s without engine speed; a 2006 GM table the CAN engine speed failing to answer. The module then works without converter slip information, usually locks out the converter clutch and may enter limp mode.
Possible causes
- Engine speed wire or connector open, or own sensor (Allison) faulty high
- CAN communication between engine and transmission module disturbed medium
- Crankshaft sensor fault in the engine module medium
- Transmission module faulty low
Symptoms
- Transmission warning lamp, possibly check engine light
- Torque converter clutch locked out
- Harsh shifts or limp mode
- Often an engine code (crankshaft sensor) as well
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P0727
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.