OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0722

Output Shaft Speed Sensor Circuit No Signal

The output shaft speed sensor (Hall or inductive) reports the speed of the transmission output; it gives the gear ratio together with input speed and on many vehicles also the road speed for speedometer and cruise control. P0722 means the output speed signal is missing while the vehicle is driving. GM's 2025 modules flag under 60 rpm for 3.5–5 s with more than 50 Nm torque and check wheel speeds as well; a 2006 GM table flags no output pulse during 6000 input pulses; Ford under 100–200 rpm for 5–30 s; Saab's Aisin box from 4 km/h. GM rates it after one trip. The transmission goes into limp mode, and speedometer and cruise control may stop working. On GM's 10-speed, P0717 and P0722 together point to the shared sensor supply.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number7 / 22

Possible causes

  • Speed sensor faulty (Hall IC or coil open or shorted) high
  • Connector or harness corroded, chafed or loose pins (with internal sensors also the pass-through connector) high
  • Metal debris on the sensor magnet or damaged reluctor wheel medium
  • Transmission module or its sensor supply faulty low

Symptoms

  • Speedometer reads 0
  • Limp mode or fixed gear
  • Warning lamp (MIL, transmission)
  • Cruise control not working

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P0722

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication