OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0721

Output Shaft Speed Sensor Circuit Range/Performance

The output shaft speed sensor (Hall or inductive) reports the speed of the transmission output; it gives the gear ratio together with input speed and on many vehicles also the road speed for speedometer and cruise control. P0721 means the output speed is present but implausible: too high (Ford 6R80 above 7450 rpm), not matching wheel or input speed in the engaged gear (ZF 6HP26 more than 200 or 250 rpm apart, Ford's F21 more than 15 % for 10 s), or jumping (Allison 1000: 500 rpm within 0.15 s). On GM's 10-speed with a direction-sensing sensor, P0721 means the reported direction of rotation does not fit – since 2025 after two trips, earlier after one. Wrong tyre sizes or a faulty wheel speed sensor can also falsify the comparison.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number7 / 21

Possible causes

  • Output speed sensor faulty or dirty (metal debris) high
  • Contact problems or interference in the sensor circuit medium
  • Wrong tyre size or axle ratio, faulty wheel speed sensor medium
  • Reluctor wheel damaged or sensor mounted wrongly low

Symptoms

  • Speedometer jumps
  • Warning lamp
  • Wrong shifts, limp mode
  • ABS/ESP warning possible if wheel speed is affected

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P0721

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication