OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0718

Input/Turbine Shaft Speed Sensor A Circuit Intermittent

The input or turbine shaft speed sensor – a Hall sensor with square-wave output or an inductive sensor with sine output – reports the speed behind the torque converter. With output and engine speed it gives the actual gear ratio, converter slip and shift timing. P0718 means the signal is present but jumps or drops out briefly. Ford's petrol modules from 2012 to 2023 count 200 turbine speed spikes above 400 rpm with at most 1.5 s between them in a forward gear. GM's Honda-built five-speed of 2006 flags jumps of more than 3 mph per 10 ms three times in 500 ms, after two trips; GM's own transmissions file such jumps under P0716 instead. Loose contacts and electrical interference are the usual causes; shifts become erratic and limp mode may follow at times.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number7 / 18

Possible causes

  • Loose contact, corroded connector or chafing high
  • Electrical interference (shielding, ground, added consumers) medium
  • Metal debris on the sensor or loose mounting medium
  • Sensor faulty internally (temperature-dependent) medium

Symptoms

  • Occasional harsh or unexpected shifts
  • Warning lamp
  • Converter clutch applies and releases unevenly
  • Limp mode at times

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P0718

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication