OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0715

Input/Turbine Shaft Speed Sensor A Circuit

The input or turbine shaft speed sensor – a Hall sensor with square-wave output or an inductive sensor with sine output – reports the speed behind the torque converter. With output and engine speed it gives the actual gear ratio, converter slip and shift timing. P0715 is the general circuit code. Ford uses it for 'no signal' too: the vehicle is moving under power (engine above converter stall speed, output speed plausible) but the sensor reports under 200 rpm for 5–30 s; Ford's DPS6 dual-clutch sets it for a hardware-detected fault of input shaft sensor 1. Subaru-based systems flag an open or shorted circuit, Saab's Aisin box no input signal while the output sensor works, substituting output speed. GM does not use P0715. Limp mode, harsh shifts and a disabled converter clutch follow.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number7 / 15

Possible causes

  • Speed sensor faulty (Hall IC or coil open or shorted) high
  • Connector or harness corroded, chafed or loose pins (with internal sensors also the pass-through connector) high
  • Metal debris on the sensor magnet or damaged reluctor wheel medium
  • Transmission module or its sensor supply faulty low

Symptoms

  • Check engine and/or transmission warning lamp
  • Limp mode with fixed gear, harsh shifts
  • Torque converter clutch does not apply
  • Input speed shows 0 or implausible in the scan tool

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P0715

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication