OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0714

Transmission Fluid Temperature Sensor A Circuit Intermittent

The transmission fluid temperature sensor is an NTC thermistor whose resistance falls as the fluid warms; the module feeds it with 5 V through a resistor. A low signal therefore means very hot or a short to ground, a high signal very cold or an open circuit. P0714 means the signal drops out or jumps briefly – not long enough for P0712 or P0713. Ford's 2012 6R80 transmission names P0714 among its fluid temperature checks for open, short and in-range faults. Ram 6.7 bulletins of 2013 changed P0711–P0714 from a one-trip to a two-trip MIL to avoid needless warnings. GM files such jumps under P0711 instead. No source publishes thresholds for P0714 itself. A loose contact in the transmission connector or a chafing internal harness is the usual cause.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number7 / 14

Possible causes

  • Loose contact in transmission connector (oil, corrosion, spread pins) high
  • Internal harness chafing from movement or vibration medium
  • Sensor with internal contact fault medium
  • Module software (false warning) low

Symptoms

  • Harsh shifts at times
  • Jumping fluid temperature display
  • Check engine or transmission lamp depending on manufacturer

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P0714

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication