OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0712

Transmission Fluid Temperature Sensor A Circuit Low

The transmission fluid temperature sensor is an NTC thermistor whose resistance falls as the fluid warms; the module feeds it with 5 V through a resistor. A low signal therefore means very hot or a short to ground, a high signal very cold or an open circuit. P0712 means the signal is too low – the sensor reads extremely hot, or the signal wire is shorted to ground. GM's 2025 transmission modules flag below 13.5 Ω for 5 of 6 s after two trips; the 2018 LT4 engine module below 17.88 Ω (over 150 °C) without MIL; the 2007 Allison 1000 150 °C or more for 2.5 s; Saab's AF40 over 200 °C; Ford below 0.05 V for 5–12 s without MIL. The module substitutes a value (coolant temperature, 80 °C or a hot mode) and may shift with hot-fluid strategy. Real overheating with a good sensor is P0218.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number7 / 12

Possible causes

  • Signal wire shorted to ground (internal harness, chafing) high
  • Sensor shorted internally medium
  • Transmission actually severely overheated low
  • Control module faulty low

Symptoms

  • Transmission in hot mode (early converter clutch, changed shift points)
  • Harsh shifts
  • Extremely high fluid temperature shown
  • Check engine or transmission lamp depending on manufacturer

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P0712

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication