OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0710

Transmission Fluid Temperature Sensor A Circuit

The transmission fluid temperature sensor is an NTC thermistor whose resistance falls as the fluid warms; the module feeds it with 5 V through a resistor. A low signal therefore means very hot or a short to ground, a high signal very cold or an open circuit. P0710 is the general circuit code used when a manufacturer does not separate low and high. Subaru-based systems (Saab 9-2X) flag 0.1 V or less or 4.7 V or more, light the MIL after two consecutive trips and use 80 °C as substitute. Ford's 2023 diesels use P0710 alongside P0712/P0713 for open and short circuits, without MIL, after 5–12 s, substituting coolant temperature. GM uses only the split codes. With the substitute value the shift quality suffers: harsh shifts and a late converter clutch.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number7 / 10

Possible causes

  • Fluid temperature sensor faulty (often part of the internal harness or valve body) high
  • Transmission connector leaking or corroded, oil in the connector medium
  • Wire open or shorted medium
  • Transmission or engine module faulty low

Symptoms

  • Harsh or late shifts
  • Torque converter clutch applies late or not at all
  • Check engine or transmission lamp depending on manufacturer
  • Implausible fluid temperature in the scan tool

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P0710

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication