P070E
Transmission Fluid Level Sensor Circuit Intermittent/Erratic
Fluid level sensors in the transmission sump report the oil level to the transmission module as a voltage; an Allison patent converts it to millimetres and only accepts readings with the vehicle at rest, warm fluid, low input speed and a tilt correction. Such sensors are mainly found in heavy automatic transmissions. No manufacturer document available to us uses this code. P070E means the level signal drops out briefly or jumps unrealistically – usually a loose contact or a wire breaking under movement. Sloshing and tilt also make readings vary, which is why valid measurements need the vehicle at rest. Because the oil level does not usually affect emissions directly, a rating without the check engine light is likely; expect a transmission warning or a missing level display.
Possible causes
- Loose contact in transmission connector or harness high
- Sensor with internal contact fault medium
- Contaminated or foaming fluid at the sensor low
Symptoms
- Fluid level display jumps or drops out at times
- Intermittent warning message
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P070E
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.