P070B
Transmission Fluid Level Sensor Circuit Range/Performance
Fluid level sensors in the transmission sump (capacitive or voltage-based) report the oil level to the transmission module; measurements are only valid under defined conditions – an Allison patent names fluid temperature, vehicle at rest, low input speed and a tilt correction. Such sensors are mainly found in heavy automatic transmissions. No manufacturer document available to us uses this code. P070B means the signal is present but implausible – it does not change, does not fit temperature or operating state, or lies outside the physically possible range. Such checks only make sense within the valid measuring window. A truly wrong oil level (overfilled, underfilled) or the wrong fluid can also appear as an implausible signal. The circuit fault is P070A.
Possible causes
- Fluid level sensor drifting or dirty (wear debris, sludge) high
- Fluid level actually wrong (over- or underfilled) or wrong fluid medium
- Contact resistance in connector or wire medium
- Faulty tilt or temperature compensation (fluid temperature sensor fault) low
Symptoms
- Warning or message about transmission fluid level
- Fluid level display implausible or unavailable
- Usually no driveability problems
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P070B
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.