P070A
Transmission Fluid Level Sensor Circuit
Fluid level sensors in the transmission sump (capacitive or voltage-based) report the oil level to the transmission module; measurements are only valid under defined conditions – an Allison patent names fluid temperature, vehicle at rest, low input speed and a tilt correction. Such sensors are mainly found in heavy automatic transmissions. No manufacturer document available to us uses this code. P070A is the general circuit fault of this sensor (open or fault in the signal circuit). Because the oil level does not usually affect emissions directly, a rating without the check engine light is likely; expect a transmission warning or a missing level display. An actually low oil level is not a P070A fault. Range, low, high and intermittent are P070B–P070E; fluid temperature has its own codes (P0710 ff).
Possible causes
- Fluid level sensor faulty high
- Wire or connector to the sensor (often through the sump or transmission connector) open or oil-soaked medium
- Transmission module input faulty low
Symptoms
- Transmission warning or 'check fluid level' message
- Fluid level display missing
- Usually no driveability problems
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P070A
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.