P0709
Transmission Range Sensor A Circuit Intermittent
The transmission range sensor (selector or multifunction switch, PRNDL) reports the selected range; it may be a multi-contact switch with a bit pattern per position, an analog sensor with two opposing voltages adding up to 5 V, or a contactless PWM sensor. Its second channel has its own codes (P2801–P2805). P0709 means the sensor A signal jumps briefly to invalid values or drops out without being permanently low or high. No manufacturer document available to us uses P0709 – Ford catches short invalid states under P0705 and P0706 instead – so the description follows the sibling codes. Sliding contacts in older selector switches are a typical source; the transmission may briefly lose the range and go into limp mode.
Possible causes
- Loose contact or corrosion in the range sensor connector high
- Worn sliding contacts in the selector switch medium
- Harness chafing on transmission or bracket, breaking when moved medium
- Misadjusted sensor or selector cable (position at the limit) low
Symptoms
- Intermittent transmission warning or check engine light
- Gear indication flickers, brief shift jolts
- Occasional starting problems in P/N
- Occasional limp mode
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P0709
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.