OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0708

Transmission Range Sensor A Circuit High

The transmission range sensor (selector or multifunction switch, PRNDL) reports the selected range; it may be a multi-contact switch with a bit pattern per position, an analog sensor with two opposing voltages adding up to 5 V, or a contactless PWM sensor. Its second channel has its own codes (P2801–P2805). P0708 means the sensor A signal is too high – a short to voltage or, depending on the circuit, an open line pulled up. GM's T87A transmission module flags a PWM duty cycle above 91.2 % for 1.8 s within 2.25 s, lamp in the first trip; Ford flags a duty cycle above 90 %, an analog sensor above 4.8 V for 5 s, a dual-analog channel above 4.84 V for 200 ms, and explicitly an open circuit on its digital sensor (all switches open, e.g. unplugged); Saab's 9-5 (9650) above 4.87 V for 100 ms twice, with 2nd gear held and a restart interlock.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number7 / 08

Possible causes

  • Sensor connector off or signal/ground wire open high
  • Signal wire shorted to voltage medium
  • Sensor faulty internally medium
  • Poor sensor or transmission ground low

Symptoms

  • Check engine and/or transmission warning lamp
  • Transmission limp mode, fixed gear, harsh shifts
  • Starting problems in P/N or start interlock
  • Wrong gear indication, reversing light not working

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P0708

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication