OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0705

Transmission Range Sensor A Circuit (PRNDL Input)

The transmission range sensor (selector or multifunction switch, PRNDL) reports the selected range; it may be a multi-contact switch with a bit pattern per position, an analog sensor with two opposing voltages adding up to 5 V, or a contactless PWM sensor. Its second channel has its own codes (P2801–P2805). P0705 is the circuit or pattern fault: the module receives a combination that matches no valid position. Ford flags an invalid pattern after 5 s (digital sensor) or 200 ms (4-bit sensor), checking continuously with the check engine light; Saab's 9-5 (9600) detects an impossible combination of its four contacts and goes into limp mode with the gearbox warning. The transmission no longer knows the range reliably – limp mode, start interlock or reversing light may be affected. Check the harness for shorts to ground before replacing the sensor.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number7 / 05

Possible causes

  • Range sensor worn, dirty or with oil or water ingress high
  • Sensor misadjusted or selector cable out of adjustment medium
  • Harness or connector at the transmission damaged, short to ground medium
  • Transmission or engine module input faulty low

Symptoms

  • Check engine and/or transmission warning lamp
  • Transmission limp mode, fixed gear, harsh shifts
  • Starting problems in P/N or start interlock
  • Wrong gear indication, reversing light not working

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P0705

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication