OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P06FD

Glow Plug Control Module 2 to PCM Communication Circuit Range/Performance

P06FD means signals or messages from glow plug control module 2 arrive at the engine module but are implausible – wrong duty cycle or pattern, feedback not matching the command, or single messages timing out. It is the counterpart of P0684 for module 1; Saab's Bosch-based diesels, for example, expect the feedback signal to be inverse to the command line. No manufacturer document available to us uses a second glow module – Ford's and GM's V8 diesels drive all eight plugs from one; the code suits systems with one module per cylinder bank. The description follows module 1 (P0684). A missing signal or open line is P06FC, a lost bus link usually U0106. The plugs of module 2 then heat poorly or not at all, typically on one bank.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number6 / FD

Possible causes

  • Loose contact or contact resistance in the feedback or bus line high
  • Ground offset between module and engine module from glow currents medium
  • Software mismatch between modules or module faulty low

Symptoms

  • Check engine light, possibly glow plug/wait-to-start lamp
  • Hard cold start, long cranking in frost
  • Rough cold idle and white smoke, often one cylinder bank only
  • Usually no symptoms when warm

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P06FD

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication