OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P06FC

Glow Plug Control Module 2 to PCM Communication Circuit

P06FC means the feedback or communication from glow plug control module 2 to the engine module is missing, or the line is open or shorted – the counterpart of P0683 for module 1. Depending on design the module reports over a single feedback wire (Bosch-type systems expect it inverse to the command line) or over the bus; GM and Ford report a lost bus link as U0106 rather than P0683. No manufacturer document available to us uses a second glow module – Ford's and GM's V8 diesels drive all eight plugs from one; the code suits systems with one module per cylinder bank. The description follows module 1 (P0683). The engine module then loses the plug status reports; implausible messages are P06FD. The plugs of module 2 then heat poorly or not at all, typically on one bank.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number6 / FC

Possible causes

  • Feedback or bus line open or shorted, connector corroded high
  • Glow module 2 without supply (does not transmit) medium
  • Glow module 2 or engine module interface faulty low

Symptoms

  • Check engine light, possibly glow plug/wait-to-start lamp
  • Hard cold start, long cranking in frost
  • Rough cold idle and white smoke, often one cylinder bank only
  • Usually no symptoms when warm

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P06FC

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication