P06FA
Glow Plug Control Module 2 Performance
P06FA means glow plug control module 2 does not respond correctly to the glow command – the counterpart of P06E5 for module 1. For module 1, Ford's 2023 Power Stroke flags internal drivers that fail to switch or overheat for more than 1 s; GM's L5P files the same check under P064C (under 3.2 A with 0 V at the plug for 3.5 s, two trips). No manufacturer document available to us uses a second glow module – Ford's and GM's V8 diesels drive all eight plugs from one; the code suits systems with one module per cylinder bank. The description follows module 1 (P06E5). Internal checksum errors are P06FB, overheating P263F. The plugs of module 2 then heat poorly or not at all, typically on one bank.
Possible causes
- Glow module 2 faulty internally (drivers do not switch) high
- Poor supply or ground of module 2 medium
- Module overheating medium
- Module software low
Symptoms
- Check engine light, possibly glow plug/wait-to-start lamp
- Hard cold start, long cranking in frost
- Rough cold idle and white smoke, often one cylinder bank only
- Usually no symptoms when warm
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P06FA
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.