P06F7
Glow Plug Control Module 2 Control Circuit Low
P06F7 means the command line from the engine module to glow plug control module 2 is too low, typically shorted to ground – the counterpart of P0383 for module 1. The engine module's output driver detects the short by its current when switched on or by the line voltage when switched off. No manufacturer document available to us uses a second glow module – Ford's and GM's V8 diesels drive all eight plugs from one; the code suits systems with one module per cylinder bank. The description follows module 1 (P0383). An open line is P06F6, a short to positive P06F8. The plugs of module 2 then heat poorly or not at all, typically on one bank.
Possible causes
- Command line to glow module 2 chafed through to ground high
- Moisture or corrosion in the connector bridging to ground medium
- Input of glow module 2 or engine module driver faulty low
Symptoms
- Check engine light, possibly glow plug/wait-to-start lamp
- Hard cold start, long cranking in frost
- Rough cold idle and white smoke, often one cylinder bank only
- Usually no symptoms when warm
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P06F7
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.