P06F5
Glow Plug Control Module 2
SAE J2012 provides a complete code family for a second glow plug control module, mirroring module 1 code for code. P06F5 is the general or internal fault of module 2, the counterpart of P064C. For module 1, GM's L5P groups driver faults (under 3.2 A with 0 V at the plug for 3.5 s) and a ROM checksum error under P064C, after two trips; Ford's 2023 Power Stroke lists P064C among the module checks with detection in about 1 s. No manufacturer document available to us uses a second glow module – Ford's and GM's V8 diesels drive all eight plugs from one; the code suits systems with one module per cylinder bank. The description follows module 1 (P064C). The plugs fed by module 2 then heat poorly or not at all.
Possible causes
- Glow plug control module 2 faulty internally high
- Poor supply or ground of module 2 medium
- Module software or configuration low
Symptoms
- Check engine light, possibly glow plug/wait-to-start lamp
- Hard cold start, long cranking in frost
- Rough cold idle and white smoke, often one cylinder bank only
- Usually no symptoms when warm
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P06F5
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.