P06F1
Reductant Control Module Internal Temperature Sensor Range/Performance
Some SCR diesels have a separate reductant control module that drives the DEF pump, heaters and dosing valve – Ford calls it the pump motor controller (fault above 130 °C under P20FF), GM's L5P an SCR power module. It measures its own board temperature with an internal sensor to protect itself from heat. P06F1 means the signal is electrically valid but implausible – it jumps, freezes or differs from comparison temperatures such as ambient or tank temperature after a long stop. Circuit faults are P06F0, P06F2 and P06F3. No manufacturer document available to us uses P06F0–P06F3; Ford and GM report related faults under P20FF or own codes. Without a valid temperature the module limits or stops heaters and pump, so dosing is restricted and an SCR warning, up to a start lock countdown, may follow.
Possible causes
- Reductant control module or pump unit faulty (sensor is on the board) high
- Water ingress or corrosion in the module (DEF crystals, underbody location) medium
- Supply or ground problems at the module medium
- Module software or calibration low
Symptoms
- Check engine light or SCR warning
- Message to check AdBlue system, possibly countdown to start lock
- DEF heating or pump inactive (no thawing in frost)
- Driveability usually unchanged
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P06F1
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.