OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P06F0

Reductant Control Module Internal Temperature Sensor Circuit

Some SCR diesels have a separate reductant control module that drives the DEF pump, heaters and dosing valve – Ford calls it the pump motor controller (fault above 130 °C under P20FF), GM's L5P an SCR power module. It measures its own board temperature with an internal sensor to protect itself from heat. P06F0 is the general circuit fault of this internal sensor: the signal is missing, open or cannot be evaluated. Range, low and high are P06F1–P06F3; the DEF tank temperature sensor is a different part. No manufacturer document available to us uses P06F0–P06F3; Ford and GM report related faults under P20FF or own codes. Without a valid temperature the module limits or stops heaters and pump, so dosing is restricted and an SCR warning, up to a start lock countdown, may follow.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number6 / F0

Possible causes

  • Reductant control module or pump unit faulty (sensor is on the board) high
  • Water ingress or corrosion in the module (DEF crystals, underbody location) medium
  • Supply or ground problems at the module medium
  • Module software or calibration low

Symptoms

  • Check engine light or SCR warning
  • Message to check AdBlue system, possibly countdown to start lock
  • DEF heating or pump inactive (no thawing in frost)
  • Driveability usually unchanged

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P06F0

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication