P06EE
Engine RPM Output Circuit High
The engine module turns the crankshaft signal into a cleaned-up square wave for the tachometer, transmission or body-builder modules – Saab's 1999 9-3, for example, sends two pulses per revolution, about 30 Hz at idle. P06EE means this output is too high, typically shorted to supply voltage, so it can no longer switch to ground; the driver may shut down for protection. It is the counterpart of P0654 (open circuit) and P06ED (low). CARB requires output circuits to be checked. No manufacturer document available to us uses this code; the description follows CARB, the component and P0654. The tachometer then reads nothing or full scale, and modules using the signal lose it, while the engine runs normally.
Possible causes
- Output wire shorted to 12 V high
- Wrongly connected accessory (speed pick-up) medium
- Receiving device faulty medium
- Engine module low
Symptoms
- Tachometer shows nothing or full scale
- Other modules without speed signal
- Engine runs normally
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P06EE
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.