OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P06ED

Engine RPM Output Circuit Low

The engine module turns the crankshaft signal into a cleaned-up square wave for the tachometer, transmission or body-builder modules – Saab's 1999 9-3, for example, sends two pulses per revolution, about 30 Hz at idle. P06ED means this output is too low, typically shorted to ground, so it can no longer switch high. It is the counterpart of P0654 (open circuit) and P06EE (high). CARB requires output circuits to be checked; the signal is emission-relevant only if a receiving module uses it for emission functions. No manufacturer document available to us uses this code; the description follows CARB, the component and P0654. The tachometer then reads zero or jumps, and modules using the signal lose it, while the engine runs normally.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number6 / ED

Possible causes

  • Speed output wire chafing against ground high
  • Receiver (instrument, add-on device) shorted internally medium
  • Aftermarket tachometer or accessory wired wrongly medium
  • Engine module driver stage low

Symptoms

  • Tachometer at zero or jumping
  • Other modules without speed signal
  • Engine runs normally

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P06ED

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication