P06EA
NOx Sensor Processor Performance Bank 1 Sensor 1
A modern NOx sensor is a smart sensor: a ceramic sensing element with pump cells and heater plus its own control unit with a microcontroller, which regulates the pump currents, calculates NOx and oxygen and sends them to the engine module over CAN. P06EA means this control unit of sensor 1 (before the SCR catalyst) reports an internal fault – its self-tests of RAM and ROM or EEPROM checksums fail – so the electronics, not the sensing element, are at fault. No manufacturer document available to us uses this code: Ford's 2023 diesels run exactly these checks continuously, with a fault after 5 s, but report them as P2200; GM uses the P2200 family and U029D/U029E. The NOx value is then invalid, so SCR dosing runs on a model or stops, a warning appears and, depending on market, a countdown to a start lock.
Possible causes
- Faulty electronics in the NOx sensor control unit high
- Moisture or corrosion in control unit or connector (underbody location) medium
- Under- or overvoltage or dips in the sensor supply medium
- Unsuitable replacement sensor or software low
Symptoms
- Check engine light or emissions warning
- Message to check AdBlue/emission system, possibly countdown to start lock
- Follow-up codes for SCR efficiency or NOx plausibility
- Driveability usually unchanged
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P06EA
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.